Posted By: ssharp
Otis 211 controller fault. - 10/14/14 02:26 PM
My controller is reading a TCI fault on the screen and will not reset. found that fuse F7 was blown but installed new fuse but can't reset elevator. I have no plans or manuals on this controller.
Posted By: Rolly
Re: Otis 211 controller fault. - 10/14/14 03:03 PM
TCI is a mode of operation not a fault. Your in Top Of Car Inspection mode. If you blew a fuse you must have a short that took you to TCI mode. Bad travel cord or pinched wires, etc etc!!
Posted By: Len
Re: Otis 211 controller fault. - 10/21/14 12:37 PM
Top of car switch contacts.have a tendency to short out..This will take out the fuse and generate ti fault on the mpu..
Posted By: Len
Re: Otis 211 controller fault. - 10/21/14 12:38 PM
Top of car switch contacts.have a tendency to short out..This will take out the fuse and generate tCi fault on the mpu..
Posted By: tony
Re: Otis 211 controller fault. - 10/31/14 12:06 AM
I had it and rotated the switch a couple times it came off...
Posted By: ssharp
Re: Otis 211 controller fault. - 11/10/14 04:20 PM
I have checked the switch and wiring but still have a fuse blower. I took the switch completely apart and ohm it out and it showed to be good. I can get controller read out to read normal run status but that's with the #346 wire unhooked in COP but car still wont run. Is the led light in the COP CPU board supposed to blink slow like the HRT light? My COP light is blinking rapidly.