Posted By: 500fpm
Otis E335m - 08/28/15 01:15 AM
I have an Otis E335m controller with a dsd 412 drive that is having leveling issues. It always overshoots the floors about an inch in both directions then levels back to the floor perfectly. Selector checks out ok LU DZ LD all show up in the proper sequence. Any suggestions?
Posted By: Magic smoke
Re: Otis E335m - 08/28/15 04:04 AM
Is it using a tape reader? If so, the guides may be worn to much, giving it to much play.
Posted By: 500fpm
Re: Otis E335m - 08/28/15 11:52 AM
It does have a tape selector and all the guides have been replaced
Posted By: jkh
Re: Otis E335m - 08/28/15 06:08 PM
If you place the car on test & inspection. Move it up or down a few inches, leave it in test mode, turn off inspection, does it level in properly?
Posted By: Magic smoke
Re: Otis E335m - 08/28/15 08:30 PM
is the loadweighing calibrated correctly?
Posted By: 500fpm
Re: Otis E335m - 08/30/15 05:00 PM
Not sure we just got the account. It doesn't show any other signs of not being calibrated correctly.