Posted By: beaupeep
Otis hydrofit - 08/31/17 02:36 AM
Anyone have info on these, particularly how to reset with the tool after completing the low oil timer test
Posted By: Alex75
Re: Otis hydrofit - 08/31/17 04:17 PM
Do you have an error like this?
E: LOS Low Oil Si 2645
Clear PF RAM in menu M-1-5-1
Posted By: NewMech
Re: Otis hydrofit - 08/31/17 07:44 PM
Clear the motion fault log
Clear the motion power failure ram
Motion reset 2-2-3-1
Posted By: beaupeep
Re: Otis hydrofit - 10/08/17 01:38 PM
Does anyone have a manual on these?
I haven't been able to get a hold of one.
Posted By: beaupeep
Re: Otis hydrofit - 05/23/18 11:31 PM
Anyone have any luck with obtaining a manual?
Posted By: solidstate
Re: Otis hydrofit - 05/24/18 12:44 AM
My bad,
I have a couple of things on them. Pm me an email
Posted By: Rolly
Re: Otis hydrofit - 05/24/18 01:41 AM
I have lots of info on them, PM me your email and what your looking for. I have prints and manuals..
Posted By: levistep
Re: Otis hydrofit - 07/25/18 07:21 PM
Does anyone know how to do a pressure test on these?
Posted By: levistep
Re: Otis hydrofit - 07/25/18 07:22 PM
Does anyone know how to do a pressure test on these?
Posted By: Elev8d
Re: Otis hydrofit - 07/25/18 11:51 PM
Jump the limit. Run on stop ring.
Posted By: hotsauce04
Re: Otis hydrofit - 07/27/18 02:32 AM
1-5-1 clears pf ram, but also need to do a 2-4-blue-enter- clears mcss ram, then 2-2-3-1. For pressure test just jump out L4S and run up on ring