Posted By: heisenberg
Error 1549 - schindler 300p - 01/23/18 02:55 AM
Getting error 1549 - RB on stand still
I've swapped over the front dual relay board on the BCM with the other lift onsite, but it just had the same fault come through.
Any ideas?
Posted By: Matt_M
Re: Error 1549 - schindler 300p - 07/22/18 09:44 AM
Hey,
Did you manage to find the cause of this ?
I am having the same issue on a new 5500.
I have also swapped the brake board to another lift and still have the same issue.
I can't find where the RB coil is energised from, so am assuming its coming directly from the ASIX board via software ?
Matt
Posted By: heisenberg
Re: Error 1549 - schindler 300p - 08/14/18 07:44 AM
Basically I tapped the RB relay on the main print, switched the unit back on and the RB relay was working again...
Seems like a bad problem for schindler. I havent had the same problem since.
Posted By: asaulis
Re: Error 1549 - schindler 300p - 08/22/18 07:13 AM
Hi, same problem 1549,what You mean "tapped" on RB relay?
Posted By: heisenberg
Re: Error 1549 - schindler 300p - 08/22/18 07:18 AM
Bang on it with a screw driver 🤔