I-Motion II Door Board Replacement

So I guess the I-Motion II door board is obsolete. Does anyone have a write up on the conversion to the new board? Kit part # or required component part #’s. I was told the new board is this AAA26800ARE1, but with the plugs for 485 comm and the load weigher removed, I’m not sure how it’s supposed to work.

Any info is much appreciated.

last time i had to deal with the i motion 2, i ordered a replacement and it came without the plugs like you indicated. turns out there are 2 different i motion boards 1 for discreet inputs, and one for serial communications they look almost identical, i did not notice until i had it in place and could not find a place for 485 and load weigher connectors.. that was a couple years back. might want to double check with parts people

2 version of this board is correct load plug is kind of in the middle of the board.

Do you have a part # for the one with a 485 plug and load weigher plug? I sure can’t find one. The old ABA26800AED is obsolete.

Had the same issue. We sent old board to unitec and had them repair it. It was about a 3 day turn around.

I think I found it. The multidrop board with load weighing is an ARE2 and requires another position sensor.