Gen 2 over speed switch

Hello. I got a gen 2 stuck in between floors with gov over speed switch out. I can not reset it. I tried with manual reset on controller and by hand at top of shaft. The tiny black cam wants to pull back away from switch. Please help

Please help ? No One has procedures to reset governor ?

Before the manual reset button will do anything, you need to enable the reset function using the handheld tool.

However, the actual switch is a little white plastic disk that sits behind the governor sheave.
If you get get to that, you're golden.

I was there. I flipped it up. But tiny cam still spring loaded to push back away from switch

Does anyone have procedures to reset ?

I might be mistaken, but perhaps the spring loaded black actuator and the microswitch have nothing to do with overspeed. It's just a thought.

Put on insp use tool go to M2251 go on to gov reset enable it then hold reset gov switch for 5 sec or so

Your activating an I/O with tool to operate a solenoid. You can also use a jumper energize the coil to reset. Check your wiring diagrams.