Posted By: sampler
Otis GEN 2 EFO - P Problem - 12/05/18 06:55 PM
Hello. I have a problem on GEN 2. Although changing EFO - P paramater as 2, the elevator travels 1st floor. Could you help me. Thanks.
Posted By: workingclass
Re: Otis GEN 2 EFO - P Problem - 12/05/18 11:29 PM
Do you have a floor below 1st? Basement?
Posted By: Indirtwetrust
Re: Otis GEN 2 EFO - P Problem - 12/06/18 02:06 AM
I think you need to change EFO-CK too.
Posted By: sampler
Re: Otis GEN 2 EFO - P Problem - 12/10/18 08:44 AM
We have basement. Floor names are -1,0,1,2,3. thanks
Posted By: sampler
Re: Otis GEN 2 EFO - P Problem - 12/10/18 08:46 AM
There is not EFO-CK parameter. Could be a diffrent name of it. Thanks.
Posted By: workingclass
Re: Otis GEN 2 EFO - P Problem - 12/10/18 11:12 AM
Where do you want it to recall to
Posted By: sampler
Re: Otis GEN 2 EFO - P Problem - 12/10/18 02:47 PM
we want to recall to "0" floor. Also the controller is GCS 222.
Best regards.
Posted By: TNHapa84
Re: Otis GEN 2 EFO - P Problem - 12/16/18 11:39 PM
M 1-3-1--6 on tool which is emergency, then go on 26 times to EFO-P landing 1-64 is front doors
landing 101-164 is rear doors
landings 201-264 is both doors
also Next is EFO-CK Change to match EPO-P
after changing Do a reset M 1-5-1
should be good
Posted By: sampler
Re: Otis GEN 2 EFO - P Problem - 12/17/18 06:53 PM
I didnt find the EFO CK
I will check again. Thank you. Best ragards.
Posted By: TNHapa84
Re: Otis GEN 2 EFO - P Problem - 12/18/18 02:51 AM
It should be right after EFO-P.... do you have a blue tool that is unlocked?
Posted By: TNHapa84
Re: Otis GEN 2 EFO - P Problem - 12/18/18 02:55 AM
Have you changed EFO-P to 1 then blue enter. Then clear ram m-1-5-1. Then tried it?
Posted By: sampler
Re: Otis GEN 2 EFO - P Problem - 12/20/18 05:17 PM
thank you very much. I will make your advice. the elevator is in another city and far away. it will go 2 weeks later. best ragards