Posted By: Dano
ThyssenKrupp Endura documentation - 01/14/19 10:11 PM
Hey guys,
Our company just picked up one of the lovely Hydraulic MRL TKE Endura units, and there is no documentation/prints on site. Hopefully someone on here has something helpful, error codes and/or prints would be good to have. Willing to pay a fair price, the UIT tool is in the controller, so at least we have that much.
-Daniel
Posted By: workingclass
Re: ThyssenKrupp Endura documentation - 01/20/19 03:26 AM
Can you send to me as well?
Posted By: danzeitz
Re: ThyssenKrupp Endura documentation - 01/22/19 01:24 PM
Never heard from Dano but PM me your contact info.
Posted By: lowoil
Re: ThyssenKrupp Endura documentation - 01/22/19 10:14 PM
In my state the code says the location for log books and such must written in the firemans key box, they send out a red box to put all documents in so if you find that you might have prints.also if you look on the usb stick there is a manual but prints I dont remember.
Posted By: Indirtwetrust
Re: ThyssenKrupp Endura documentation - 01/23/19 12:55 AM
The prints will be on the stick too
Posted By: Whadafack
Re: ThyssenKrupp Endura documentation - 02/07/19 03:15 AM
Did u check inside the cabinet on the hoistway side? Sometimes its in there.
Posted By: Philelevman
Re: ThyssenKrupp Endura documentation - 02/09/19 04:59 PM
I have 2 of these that were just flooded by a ruptured sprinkler line. The only issue I'm having is programming the new cpua board. Followed the manual exactly and no love. I am not a fan.
Posted By: lowoil
Re: ThyssenKrupp Endura documentation - 02/09/19 06:44 PM
You might have corrupted software
Posted By: Rolly
Re: ThyssenKrupp Endura documentation - 02/09/19 08:27 PM
Or this may take a higher version of IMS then the 2.4.x.x that is out on the market.