Hand held for reprogramming a Millar CVT

Anybody know of how to get a hand held for a Millar CVT?

which model ?

CVT Elon 1000 = Tricon (Othompson) now MCE
CVT 2400 = Series 90 (Othompson) Call MCE (series 90 has integrated display CVT 2400 use same boards with HandHeld and no display and board connectors are differents)
CVT Net = Ultra 2000 (Othompson ) no handheld
CVT (dont remember the Name) = Miconic A (Shindler) use a Shindler HHT

CVT Macroscan OLD no HandHeld use a Computer Terminal just HandHeld for the drive is GE OLD model

Not real sure I don't know how to post pictures of the controller? It says CVT but I heard someone say they thought it was a Miconic?

Same as Schindler Miconic A

buy a HHT

https://eciamerica.com/diagnostic-tools/sdt-1180/

or World Electronics (real Expensive)

Thank you!

That picture is of a Schindler old name was epoch 2. Also Called a miconic a use Schindler h h t handheld also world electronics sells word tool s that works

There is a software program for laptop called HHT. Works great!!

Your picture is Miconic A or possible Epoch2 VA.
Millar CVT used a rather strange keypad with three buttons on the side and then a grid in the front. Some people rigged up the old little Tandy computers as well. Millar CVT was basically an early version of Swift just laid out like a science fair project

Do u know any password or logins for the cvt 8600

Millar CVT 8600 hand held can be acquired through Bart Elevator in NYC. Works great.