Otis SPEC 60 (MRQ) security

I have a customer who wants to add security to their 2 passenger cars with SPEC 60 (MRQ) controls. I know that the calls are serial and this will require some hardware to make it work. The existing job prints are missing some pages and I don't know for sure if there was anything in those pages that would have shown board addressing and wiring for the serial boards needed. I dug up an Otis article on how to program card reader operation for this type of equipment but I don't know if I can order a kit from Unitec for this project or if I have to piece meal it all together? Does anyone have a set of prints from a job that had security? I think I can use RS5 boards but I don't know what they should be addressed to either. Anyone's help would be greatly appreciated.

Unitec will sell you a card reader "kit". Has RS5's, and little terminal strips in a 12x12 jbox

You'll have to program obviously

Hey Philly. I asked our local Unitec rep about that and he either didn't know about it or doesn't have the info for it. Do you happen to have a part number or any reference I can use to request that? I stumbled onto an article on the programming but I'm more concerned with the addressing of the RS's. Might you have any info regarding that or know how to get it?

I can get you the part number for the security "kit" i ordered from unitec.

Programming is too complicated to explain here, if you go ahead and sell the customer on it, i can try to help you over the phone. You obv need the tool.

Thanks Philly. Much appreciated. I will take you up on it.