Posted By: Jluff
Westinghouse MPH2 - 02/14/19 02:42 PM
Doors will not open when car arrives. It’s it’s intermittent but most of time doors do not open. I replaced encoder eyes that bounce off the reflectors in shaft and that did not solve the problem. By the way no prints and Adams wants $2,000 for new prints. Should I replace the 4 FCB boards in the car station panel ?
Do you have the yellow hand held tool from ECI? (Florida not Canada) Will the doors open if you use the DOB after the car stops? Do the doors operate correctly from the manual switches on the door board?
Posted By: Adam09
Re: Westinghouse MPH2 - 06/05/19 08:19 PM
Hello I have the same issues and the doors will open with the DOB button pressed when it stops and doors operate normally with the manual switches. Any other advice? I have swapped relays on relay board and nothing