Schindler 3300

hey guys, looking at the 3300 for maintenance. Are they non proprietary or proprietary. i know i can purchase parts from adams but is there anything to watch out for control wise?

3300 is far better for configuring than the 5500

Pm me if you need further info on them

What is an 35 state on 5500?

You have any adjusting or testing manuals on pdf for the 3300?

hi id just want ask to anyone have experience in schindler escalator the question is after the testing and commissioning and they switch for long time and don't know if there is a secret sequence how to run by inspection mode.. its is possible also even there in no chipcard.. Schindler Escalator PEM52

3300 is widely used in Europe and is regarded as cheap junk by many.
More trouble than they are worth in my opinion.

I think most important point is brake. test, gap.

Are there any diagnostic tools needed for maintaining or are the on board diagnostics good enough?

at 5 years or 1,000,000 trips the suspension traction media (black belts) must be replaced. you get a code with the new belts to enter into the controller to reset the trip counter. its not like the gen2 where you can fool the pulse unit that checks the belts. any problems with the brakes and you toss them and buy new. sure you can set the gap. but ive seen where they just wont stop and a new brake is the only solution. its the same old game with the big 4. sure its non proprietary. but if you have to buy parts, it takes a long time to make your money back for what you charge on a full maintenance agreement. i just bought a new qks16vvvf operator for a 330 and it was 4500 bucks. ouch.