Posted By: upndn33
Tac 50-04 - 03/12/19 08:36 PM
I’m getting an ntsd error as well as a ntsd clamping error.this is a mod which has a tape with the perforated holes any help would be great.i changed the board and it ran for a few hours but crapped out again.i also did a learn run
Have you checked the magnets on the back of the tape?
Posted By: elmcannic
Re: Tac 50-04 - 03/13/19 04:13 PM
By “checking the magnets” as IDWT suggested, did you look carefully to be sure there are no gaps at all between magnets, and are they glued in place?
Posted By: Whadafack
Re: Tac 50-04 - 04/13/19 12:16 AM
Do a tbs. adjust your decel before you do it. Bring it up while u do the scan then back down to its original settings