Posted By: heisenberg
Schindler 5500 door drive programming - 08/06/19 06:11 AM
Anyone know anything about programming the dde-v35 door drives on a schindler 5500?
Does It need to be programmed with the hand tool? Can be programmed through cadi?
Posted By: Alex75
Re: Schindler 5500 door drive programming - 08/06/19 02:12 PM
Do you mean the Varidor 35 door machine? (not sure about the "dde"?)
Posted By: sampler
Re: Schindler 5500 door drive programming - 08/17/19 07:52 PM
you can only programme speed rate and learning with keypad that is on the door. all parameters inside the controller. you can adjust via menu.
Posted By: Meprom21
Re: Schindler 5500 door drive programming - 08/18/19 04:51 PM
Does anyone have any manuals on the 5500 they would like to share or trade for? I do have a variety of other manuals/prints i could help with. Thanks
Posted By: heisenberg
Re: Schindler 5500 door drive programming - 08/23/19 12:05 AM
Can we activate heavy door mode via the smlcd? Or do we need the door drive hand tool?
Posted By: sampler
Re: Schindler 5500 door drive programming - 08/23/19 07:28 PM
there is no hand tool for the door. you can activate via SMLCD.
Posted By: Alex75
Re: Schindler 5500 door drive programming - 08/24/19 05:16 PM
You have to define the "Floor Map table" for landing doors with normal- / heavy doors.
On the SMLCD go to:
- Login -> Parameters -> Door -> LanDoorWeight
For each floor level:
- Enter physical floor numer:
- Floor = 1 -> OK
- Set door weight to:
- Normal Door or Heavy Door.
/Alex
Posted By: heisenberg
Re: Schindler 5500 door drive programming - 08/26/19 04:48 AM
Thanks guys, much appreciated