Posted By: Mike G
Tac 32T - 02/14/20 01:57 AM
Just took on a few of these units, have a car stuck in “Init Shutdown” after a loss of power. Have not encountered this when the car has had the line out in the past. Nothing indicative of this in the fault log, reset faults, etc. Any idea?
Posted By: Rolly
Re: Tac 32T - 02/14/20 01:49 PM
Do you have IMS? If so what version?
Posted By: wltr00
Re: Tac 32T - 02/14/20 02:15 PM
Open your IO map and check your IO’s. There is a mismatch or an IO in the wrong state.
Posted By: 1Jr8c6
Re: Tac 32T - 02/14/20 04:27 PM
There are a few 2a pico fuses on the cpu I have had One of them blow after a building power issue gave me a similar issue. Worth a shot just make sure you pull them to check them.
Posted By: Rav4guy
Re: Tac 32T - 02/28/20 03:19 AM
Hello friends. I have IMS software. IMS 32 bit ,16 bit
I also have the latest version of IMS 2.7 now.
Email me at rav4guy@live.com for details.
Posted By: REJIVIJAY
Re: Tac 32T - 02/28/20 03:40 AM
replace the CPUA software.
Posted By: Jblack83
Re: Tac 32T - 11/03/21 12:21 AM
You ever get this resolved? I am having a similar issue. I n i t shut down. 1014 fault. I got that to go away using IMS fast command "GET". Then "WRT". Now though it is having a RUN MNT shutdown. Won't run up on inspection. Any ideas?