Posted By: BillS
330A question - 05/13/20 10:03 PM
I have a few questions about working with the 330A.
Can everything with these be managed from the controller ? (not the hydraulics, of course)
Can any parameters be changed or does one then need new software from Schindler if you need to make a change?
Are all menus and submenus accessible?
Are there any special tools needed?
Are there occasions when the controller locks up and cannot be reset without going back to Schindler?
Can everything with these be managed from the controller ? (not the hydraulics, of course)
Can any parameters be changed or does one then need new software from Schindler if you need to make a change?
Are all menus and submenus accessible?
Are there any special tools needed?
Are there occasions when the controller locks up and cannot be reset without going back to Schindler?