TMS 50

I keep getting two error codes 50 & 12. Mostly error 12 Anti Creep on a hydraulic lift three floors with a TMS50 controller.
Can some one help me solve this one.

ANTICREEP FAULT FIRST TIME ERROR: 50
ANTICREEP IN FAULT ON 2 CONSECUTIVE DRIVES ERROR: 12

Thanks Rolly. Do you have any idea what would cause this fault. Do I need to do a learn run? If so how is this carried out.

Maybe Rope Gripper contact

If you don't have a rope gripper could be a dip switch setting. Or Possibly a brake poblem.. micros etd..

Thanks Rolly. This unit is a hydraulic, so no brake. The Governor switch is all good. The dip switch is number 3, tried it in the other position but no change so returned it to its original position. I don't understand your reference to (micros etd)
Any other suggestions would be greatly appreciated.

Maybe brake switches need checking?

Had a lot of bad boards.. Low end junk system. make sure you get the right board for your silk screen cover if you do get a new board,

Error 50 is Faults on the locking magnet have not caused two faults in succession in my book...

Thanks Jadam.
What do you mean re the LOCKING MAGNET? can you expand your knowledge on this device.
Thanks

Send me you mail address and i will send you the info