Posted By: Tweeker
Dover 68 door operator controlled by a tk smarttec - 11/21/20 01:19 AM
I have old dover 68 wedge operator being controlled by a TK smarttech change over board. Im getting an I FBK fault. Stopping the door from opening. It will run for several floors with no problems then it will fault out and not open. I've changed door motor and door board 6300pa6 board same fault persists. Any ideas would be appreciated!
Posted By: Jluff
Re: Dover 68 door operator controlled by a tk smarttec - 11/23/20 02:31 AM
They may be a big capacitor under the door board causing the door to not open .. it’s blue I think.
Posted By: lowoil
Re: Dover 68 door operator controlled by a tk smarttec - 11/23/20 02:00 PM
First thing I check when not getting door open is door close limit.
Posted By: Indirtwetrust
Re: Dover 68 door operator controlled by a tk smarttec - 11/24/20 12:42 AM
You aren’t going to find a capacitor under a PA6 board but did you replace the encoder with the motor?
Posted By: TC7
Re: Dover 68 door operator controlled by a tk smarttec - 11/28/20 09:37 PM
I've had this before. I think it is too much current when holding the doors close during a run. I bet you only find it faulted with door closed. I bet manual door speed is set way too high. I never set manual speed higher than 60-75.