Posted By: Elevator_Logic
Replacing Selector Board on TAC - 02/03/21 07:05 PM
I am going to replace a selector main sensor board ( Part number 6300ACK1 to replace Part number 6300ACK2). Will I need to perform any programming for just swapping out this board?
Posted By: Elevator_Logic
Re: Replacing Selector Board on TAC - 02/04/21 01:15 AM
Alright that is done with the IMS software right? I have the IMS software but haven't attempted a shaft set-up yet with it.
Posted By: elmcannic
Re: Replacing Selector Board on TAC - 02/04/21 02:57 AM
Follow the instructions in the manual to perform the selector set up. You do have the manual right?
Posted By: Elevator_Logic
Re: Replacing Selector Board on TAC - 02/04/21 08:25 AM
No worries Elmcannic a few helpful people sent me DMs on how to perform it.