Posted By: heisenberg
Kone parameter unlock LCE V6.7.18 - 06/08/22 08:21 AM
Anyone know of a unlocker tool that will unlock a Kone lce with 6.7.18 version software?
I've tried a relatively cheap unlocker tool and Modutool, both unsuccessful.
Posted By: Alex75
Re: Kone parameter unlock LCE V6.7.18 - 06/08/22 02:31 PM
Dont think it can be done, KONE always put this software version in, when they the loose a unit.
Just update the software to a higher version, then use the LCEUIO or Modutool to unlock the interface.
/Alex
Posted By: heisenberg
Re: Kone parameter unlock LCE V6.7.18 - 06/09/22 12:58 AM
Can you help me through the process of updating the software?
Posted By: heisenberg
Re: Kone parameter unlock LCE V6.7.18 - 06/09/22 01:40 AM
Or can the KNX board unlock parameters?
Posted By: andy71
Re: Kone parameter unlock LCE V6.7.18 - 04/16/23 10:12 AM
Please kone unlock lce parametro cpu..thanks
Posted By: wikilift
Re: Kone parameter unlock LCE V6.7.18 - 04/21/23 08:03 AM
if the drive still has the nvram, not the soldered memory, it will suffice to fill it with FF and put it back, but you will need to re-enter the install parameters. This process can be tedious if it is a device with special characteristics, if it is a standard device with a single entrance and without keys, all you have to do is read the hole to recognize the floors and address the remote stations (floor plates )