RS232 To USB not working

Greetings
I am using terminal with Smart.Trm on a Schindler smart mrl 002 elevator.
My connection is as follows male connector - female null modem - female null modem
- male RS232 connector to usb comm port 2 in terminal settings.
I can list the commands in terminal but I am not receiving data, anyone else had this issue.
What is your settings in terminal? Must I put on a dip switch?

Thank You

Greetings

Is the problem my RS232 cable?

can you show the cable photo by uploading

What version of the SCIC pcb do you have? Some the earlier ones had a different com setting then the later ones....

Greetings

My SCIC pcb Version 3.1. V3.1 is old. no wonder my RS232 to USB is not connecting. Anyone know if I can do a dip switch to look at errors on the COP?

Thanks Alex75 & Sampler.

Greetings

Anyone with pdf on SCIC PCB V3.1?

Bless

The com settings for a SCIC Q3.1 board shoud be as below....

Baud Rate 9600
Data Bit 8
Parity None
Stop Bit 1
Flow Control OFF

Any hyperterminal should be working or Cadi Bionic.

Greetings

Used the SCIC 3.1 Com settings, shows the commands in both Cadi Bionic & Terminal but not receiving any data from the SCIC..
Also used a null modem.

Cheers

Alex75, do you know terminal can be used instead of cadi bionic for 3300 model