Posted By: Timothy A. Jones
Monarch Shaft Auto Tune not responding - 08/10/22 01:01 AM
I'm currently trying to Perform a shaft auto-tuning on a Monarch NICE 3000 Drive
All safety switches are ok because I'm getting X25, X26, X27 voltage active on MCB
All relevant signals are in the right state and was set as indicted on document given
the elevator is on inspection state and Shaft Auto-tuning is activated by setting F1-11 to 3 on the operation panel, the display changes without performing the Shaft auto-tune
Can anyone direct me on what I'm missing to cause the drive not to perform the auto tune.
All safety switches are ok because I'm getting X25, X26, X27 voltage active on MCB
All relevant signals are in the right state and was set as indicted on document given
the elevator is on inspection state and Shaft Auto-tuning is activated by setting F1-11 to 3 on the operation panel, the display changes without performing the Shaft auto-tune
Can anyone direct me on what I'm missing to cause the drive not to perform the auto tune.