Posted By: Jluff
Tac 20 PI - 01/25/23 08:04 PM
Hi. I have a tac 20 PI in lobby that was dead. There is a PI in car and lobby .. car PI is working fine . After reset on the board it came back on but the pixels were messed up. You could barley read floors but it was stepping correctly with correct floor denotations. This PI has 2 boards attached to each other. A main cpu board and then the display board. Can I just replace the display board for this problem ? Is the main CPU board a plug n play ?
Posted By: Jluff
Re: Tac 20 PI - 01/27/23 05:03 PM
Nobody wants to talk Tac 20 PIs ?? š
Your can replace just the display board but I kind of doubt thatās the problem. You could try swapping just the display board with the car PI to find out. Not much to replacing the LONPI board as long as it isnāt super old with other bound PIs on the channel. Just match the jumpers. I have seen them come out without NXE files before but thatās been several years now.
Posted By: Jluff
Re: Tac 20 PI - 01/30/23 05:57 PM
Thanks dirt. So you think I need to replace both boards to solve thf problem ? The LONPI board is $2000
If JP1 2-5 are NOT all off, itās all plug & play. You can swap the car and hall boards to test, just match the dip switches.
Posted By: Jluff
Re: Tac 20 PI - 01/31/23 12:48 PM
JP1 3 is on. 1-2-4-5 are off š