Tms600 setup problem and e7 error

Hi!!

I have a tms600 with the v3f20 drive.i just change the main board from the drive and iam trying to do the setup learn as manual saying.it starts ok but after passing first floor the elevator stops and sfail starts blinking in drive. Also I am having an e7 error in the display all the time of the tms 600. Any help will be appreciated!!!

Anyone knows what e7 error is? I believe this is the problem that I can't setup drive.

Anyone has tms600 error codes?

E7 PARAMETER REBOOT DONE
- Field parameters has been copied from factory or EPROM parameters
+ Use function FC to receive this information

Check and double check all jumpers and potentiometer settings from old board.

Did you replace V3F or TMS board?