Posted By: bill
KCM 831 Hydro - 01/30/11 08:22 PM
If anyone has kone kcm hydro prints i would appreciate it i have had it on service since late 2005 and only had a couple easy calls until now. My e-mail is gator2002@aol.com. Thanks
Posted By: aquadag
Re: KCM 831 Hydro - 03/02/11 04:17 AM
whats your problem? I have all kcm error codes but they are for the eco space, I think they are pretty much the sane though
Posted By: bill
Re: KCM 831 Hydro - 03/22/11 11:32 AM
Thanks for reply. Yes they are the same and i did get the info i needed. I had a bad adon card. It was $2500 w/ trade in. I have bought entire controllers from Elevator Controls for far less then one card from Kone spares.
Posted By: J Sand
Re: KCM 831 Hydro - 03/23/11 12:11 AM
Unfortunately very common. Had to replace two in the same week. Even the KONE guys change at first sight of problems.
Posted By: aquadag
Re: KCM 831 Hydro - 03/24/11 12:44 AM
the older ones had alot of manufacturing problems, according to their support staff the new ones are much better
Posted By: J Sand
Re: KCM 831 Hydro - 03/24/11 02:06 AM
Yeah, heard the same but the two I changed out were both Version 2's. Version 1 had a lot less ack lights and uses Schrack relays (which are garbage).