Does anyone know how to add a car call cutout switch to a TAC 50. It looks like I have to add a input/output module to a PMI board. I have never done this plus I have no info on the job on how to do it. I have a TAC 50 tool but no instructions.
#6689 - 04/20/1310:58 PMRe: Adding a car call key switch to a TAC 50
[Re: Mugimus]
Just a note to remember, you can add a key switch to a serial data lift in any position, as whether you are switching a hard feed or a feed that gets multiplexed(or whatever) you are still switching something and it will work just the same.