does anyone have a wiring diagram for a garaventa genesis vertical hydro lift?

Is it not printed on the inside of the cover?

no nothing there

What print number do you need? There should be a sticker on the duct covers inside the controller or on the cover of the controller or inside the cover of the controller. I need the schematic number and/or the wiring diagram number and the revision letter.

Thank you in advance. I should be at the job sometime this week I will look for the numbers and post them here.

I have a print I need to scan it.

aquadag thank you for letting me know you have a print. If you could scan it and email it to kent@reliableelevatorfl.com I would appreciate it.

Johnny I was at the job the only number on the equipment is the ser. no. 27947

There should be a paper label inside the controller. On the older jobs, it was stuck on the wiring duct covers. On the later models, it is inside the controller. Did aquadags print work? Give me some more info and an email to send them. PLC? Garavents PDOs? Powerlocks or mechanical locks? Solenoid relays inside the controller or below the controller?

aquadags did not send a print. I have this unit running but would like a print for future use. It has power doors,solenoid relays inside the controller.

give me an email and I send several

I nneed a schematic for a Genesis lift also. Serial # 29650

Hello,
I need an electrical schematic for Garventa Genesis (command only made ​​by relays) without electronic boards. In Portugal it is difficult to find out this information ... can you help me?