Dover Solid State, oildraulic, 2 stop -four card

You are not logged in. [Log In] Home Forums Technical Questions Dover Solid State, oildraulic, 2 stop -four card

0 registered members (), 21 guests, and 2 spiders.

Key: Admin, Global Mod, Mod

Newest Members

Forum Statistics

Forums13

Topics6,528

Posts36,942

Members8,461

Most Online117
Jan 16th, 2020

Print Thread

#10254 - 03/31/14 02:44 PM Dover Solid State, oildraulic, 2 stop -four card
Joined: May 2013 Posts: 44 hirise Mechanic
hirise Mechanic Joined: May 2013 Posts: 44	Can anyone tell me if there is any special procedure for replacing the boards? Should the Power card go in first, alone, and then the 5 Volt power supply adjustment be made and then (line out) the remaining boards be inserted? Also how do you get to the voltage adjustment pot on the power board when it is inserted? - I didn't see a removeable cover for access.

#10255 - 03/31/14 03:18 PM Re: Dover Solid State, oildraulic, 2 stop -four card [Re: hirise]
Joined: Jan 2012 Posts: 885 jkh 4 Ever Learning.
jkh 4 Ever Learning. Joined: Jan 2012 Posts: 885	The power should be off when ever you want to remover any of the boards. You will risk damaging them if you remove them with the power on. Sorry I don't know any short cuts on adjusting the power supply. Make good choices, JKH

#10256 - 03/31/14 03:31 PM Re: Dover Solid State, oildraulic, 2 stop -four card [Re: jkh]
Joined: May 2013 Posts: 44 hirise Mechanic
hirise Mechanic Joined: May 2013 Posts: 44	JKH thanks for the quick reply. Kinda crazy to a have a volt adjustment pot that canot be access with power to the board !

#10269 - 04/01/14 11:06 PM Re: Dover Solid State, oildraulic, 2 stop -four card [Re: hirise]
Joined: May 2011 Posts: 487 E-man addict
E-man addict Joined: May 2011 Posts: 487	Use an offset plastic pot tweaker. I use an orange stick because IIRC, the pot wheel is knurled on the side.

Photo Gallery