Hi everyone
We are having the below issue with this car:
1- we have a 400a that is down right now. We had a ton of info on the job but it is all disappeared. We have fault 0067 which shows KUET fault. It says to check RUET and RUET1 relays and says they should be firing in tandem and also not in tandem which I don't understand. I can find RUET relay but can't find RUET1 relay. Where is it?
Our symptoms are this- we just took it over from schindler. Went to perform a test today and as soon as we put it on ph 1 fire service the car came down doors wouldn't open. Went to the controller and found a blown fuse (s1e I believe) it is rated for 4a but had a 2a in it. We replaced that and now we can run the car on inspection but when try to run on automatic the call latches the brake picks drive kicks on but car doesn't move. Then after a few seconds we get fault 0067.
This car was running fine until we tested fire service than BAM! The wiring on this thing is a mess, boards hanging out, inspector who passed it lost his license here in FLA (this part is me just venting now!!!)
Got any suggestions? Got any manuals or write ups for this?
Thanks