Otis 211 controller fault.

You are not logged in. [Log In] Home Forums Technical Questions Otis 211 controller fault.

1 registered members (ot1989), 16 guests, and 3 spiders.

Key: Admin, Global Mod, Mod

Newest Members

Forum Statistics

Forums13

Topics6,506

Posts36,833

Members8,461

Most Online117
Jan 16th, 2020

Print Thread

#12319 - 10/14/14 02:26 PM Otis 211 controller fault.
Joined: Apr 2012 Posts: 25 ssharp newbie
ssharp newbie Joined: Apr 2012 Posts: 25 Oklahoma	My controller is reading a TCI fault on the screen and will not reset. found that fuse F7 was blown but installed new fuse but can't reset elevator. I have no plans or manuals on this controller.

#12320 - 10/14/14 03:03 PM Re: Otis 211 controller fault. [Re: ssharp]
Joined: Jan 2014 Posts: 736 Rolly old hand
Rolly old hand Joined: Jan 2014 Posts: 736	TCI is a mode of operation not a fault. Your in Top Of Car Inspection mode. If you blew a fuse you must have a short that took you to TCI mode. Bad travel cord or pinched wires, etc etc!!

#12408 - 10/21/14 12:37 PM Re: Otis 211 controller fault. [Re: Rolly]
Joined: May 2012 Posts: 194 Len member
Len member Joined: May 2012 Posts: 194	Top of car switch contacts.have a tendency to short out..This will take out the fuse and generate ti fault on the mpu..

#12409 - 10/21/14 12:38 PM Re: Otis 211 controller fault. [Re: Rolly]
Joined: May 2012 Posts: 194 Len member
Len member Joined: May 2012 Posts: 194	Top of car switch contacts.have a tendency to short out..This will take out the fuse and generate tCi fault on the mpu..

#12534 - 10/31/14 12:06 AM Re: Otis 211 controller fault. [Re: Len]
Joined: Oct 2012 Posts: 36 tony newbie
tony newbie Joined: Oct 2012 Posts: 36	I had it and rotated the switch a couple times it came off...

#12682 - 11/10/14 04:20 PM Re: Otis 211 controller fault. [Re: tony]
Joined: Apr 2012 Posts: 25 ssharp newbie
ssharp newbie Joined: Apr 2012 Posts: 25 Oklahoma	I have checked the switch and wiring but still have a fuse blower. I took the switch completely apart and ohm it out and it showed to be good. I can get controller read out to read normal run status but that's with the #346 wire unhooked in COP but car still wont run. Is the led light in the COP CPU board supposed to blink slow like the HRT light? My COP light is blinking rapidly.

#12809 - 11/22/14 11:29 PM Re: Otis 211 controller fault. [Re: ssharp]
Joined: Oct 2012 Posts: 36 tony newbie
tony newbie Joined: Oct 2012 Posts: 36	did you find the problem

Photo Gallery