I recently acquired a contract that has several Schindler 300A 2 stop hydros. In less than a month I have had to replace the relay board on one and both the CIO and MIO boards on another. The one that I replaced the IO boards on would call and run from the second landing, but when you tried to go from 1 to 2 in auto, it would fire up for a split second and then fault out with a photo sw error and beam sw shrt message. All the photo switches were working fine and the freedomware tool that I have for the unit said the IO's were firing high and low just fine. Is this a normal problem with these controllers. Do they have a tendency to blow boards out. The CIO board looked like it had been on fire. Any insight would be great