Hi all, I have inherited a Carlos silver Hidra lift on my round that runs ok for a week or two then the lift stops (always at floor level) when you press the hall button the light in the button flashes and the doors wont open. If you open the doors and look in the car the car display is showing a smiley face which means it has a communication fault!
The main board looks like it has had moisture on it at sometime.
Has anyone out there had any experience with this equipment.
All help will bd greatly appreciated.
Thanks in advance.

Google Carlos Silva Lift and there is an email address for help, or a phone number to Barcelona if you wanna try that route.
That's all I can find.
Good luck!

Check your PLR and DMR modules are communicating with the main board
(steady flashing LED)

Thanks thyssenkrapp, where are the PLR and DMR modules located?

Should have a DMR for the car and PLR at each landing