In between floors.
700 Fault, memory F.
Big S took SIMM card.
Any idea of fault?
Thanks

700 Memory Failure Occurs when the Schindler AC drive memory cannot be
accessed due to a disconnected drive serial cable, bad re-boot, or defective PVEC or
PIOVEC board. Possible fix: Check the serial cable connection on the drive and
ASILOG board. Turn the main line disconnect OFF. Disconnect the controller 12 volt
battery by disconnecting the X3-1-1 connector on the ASILOG board. Wait 1 minute.
Plug X3-1-1 back in and turn the power back on.

Sccjr, thanks will try it in next few days.