Tac20

You are not logged in. [Log In] Home Forums Technical Questions Tac20

0 registered members (), 20 guests, and 0 spiders.

Key: Admin, Global Mod, Mod

Newest Members

Forum Statistics

Forums13

Topics6,519

Posts36,895

Members8,461

Most Online117
Jan 16th, 2020

Print Thread

#18048 - 09/19/16 10:19 PM Tac20
Joined: Oct 2013 Posts: 113 chicago member
chicago member Joined: Oct 2013 Posts: 113	Getting 1041 fault. TAC20 ???don't remember this one..

#18049 - 09/19/16 10:28 PM Re: Tac20 [Re: chicago]
Joined: Mar 2011 Posts: 149 xxXBlazeXxx member
xxXBlazeXxx member Joined: Mar 2011 Posts: 149 Ga.	Door WatchDog closing failure � DCL input did not activate in expected time interval. S Verify D21 and/or D22 adjustments Last edited by xxXBlazeXxx; 09/19/16 10:29 PM.

#18054 - 09/20/16 01:04 AM Re: Tac20 [Re: xxXBlazeXxx]
Joined: Dec 2010 Posts: 566 elmcannic addict
elmcannic addict Joined: Dec 2010 Posts: 566 S. Central Utah	Chicago- Be sure to check the door motor brushes. Closing torque Close start settings Dragging gib Too slow a manual close setting Marginal DCL input Soft spot on the primary door belt right near full close New belts= excess drag on motor= 1041 Be sure you don't have a door ramp preventing full door closure Or--- If it uses that magnet on the header for DCL, that may be a culprit as well. Be sure to let us know what you found to remedy your trouble

#18072 - 09/20/16 11:27 PM Re: Tac20 [Re: elmcannic]
Joined: Oct 2013 Posts: 113 chicago member
chicago member Joined: Oct 2013 Posts: 113	Elmcannic, nice tips. I will be back to job friday. Will check your ideas. Thanks

Photo Gallery