Schindler 330a hall board

You are not logged in. [Log In] Home Forums Technical Questions Schindler 330a hall board

0 registered members (), 15 guests, and 1 spider.

Key: Admin, Global Mod, Mod

Newest Members

Forum Statistics

Forums13

Topics6,519

Posts36,895

Members8,461

Most Online117
Jan 16th, 2020

Print Thread

#18467 - 10/25/16 05:14 PM Schindler 330a hall board
Joined: Jan 2016 Posts: 12 alwaysfixin stranger
alwaysfixin stranger Joined: Jan 2016 Posts: 12	This single 330a 5 stop hydro is having problems at the 4th floor. It will not register a call. The hall board has been replaced an swapped with other floors, we have checked the rotary switch. I assume if a plug in wire is bad then all the buttons would work since it is in series? Does anyone have any ideas?

#18471 - 10/25/16 07:06 PM Re: Schindler 330a hall board [Re: alwaysfixin]
Joined: Jan 2014 Posts: 736 Rolly old hand
Rolly old hand Joined: Jan 2014 Posts: 736	You clear faults and are cycling power when you change a board?

#18475 - 10/25/16 10:00 PM Re: Schindler 330a hall board [Re: Rolly]
Joined: Jun 2015 Posts: 30 firbug13 newbie
firbug13 newbie Joined: Jun 2015 Posts: 30	Sometimes they are stubborn to accept new boards and you have to power down and drain the capacitor on the 360 board completely and then fire it up and you should be good. you can also check the to see if the node is good.

#18476 - 10/25/16 11:08 PM Re: Schindler 330a hall board [Re: alwaysfixin]
Joined: Oct 2013 Posts: 175 NOTIME member
NOTIME member Joined: Oct 2013 Posts: 175	Originally Posted By: alwaysfixin This single 330a 5 stop hydro is having problems at the 4th floor. It will not register a call. The hall board has been replaced an swapped with other floors, we have checked the rotary switch. I assume if a plug in wire is bad then all the buttons would work since it is in series? Does anyone have any ideas? the elevator acept the call before ? did you see ? if not you remplace the board more than 1 time ? sometimes recives bad hall boards swap 5 to 4 and reconfig the sw and reset the controller maybe is lock in the controller i cant remember the menu but has somthing for floors

#24860 - 09/27/18 03:26 AM Re: Schindler 330a hall board [Re: alwaysfixin]
Joined: Aug 2017 Posts: 2 Amp Malik
Amp Malik Joined: Aug 2017 Posts: 2	we replace schindler hall call PCB i dont know ho to set the floor selection adress PCB has no any dip switch and rotry switch paleas help me out.

#24863 - 09/27/18 12:14 PM Re: Schindler 330a hall board [Re: alwaysfixin]
Joined: Dec 2017 Posts: 37 Huskervator newbie
Huskervator newbie Joined: Dec 2017 Posts: 37	You may have the wrong board. Your replacement board should be either a 222836 or 222837. The easy way to replace is to duplicate your new board settings with the one you are replacing. Your job drawings show also the setting of the switchs.

Photo Gallery