tac 50 04 load weigher

You are not logged in. [Log In] Home Forums Technical Questions tac 50 04 load weigher

0 registered members (), 20 guests, and 2 spiders.

Key: Admin, Global Mod, Mod

Newest Members

Forum Statistics

Forums13

Topics6,521

Posts36,915

Members8,461

Most Online117
Jan 16th, 2020

Print Thread

#19600 - 02/16/17 11:34 PM tac 50 04 load weigher
Joined: May 2013 Posts: 224 Jcjmowrey enthusiast
Jcjmowrey enthusiast Joined: May 2013 Posts: 224 Atlanta ga	Does anyone have the setup procedure for a EMCO canrtm load weigher on a tac 50 04. I found one today that was unplugged at the cwik board, when I plugged it back in and put it on auto it went straight into saying it was overloaded with the alarm sounding. I'm thinking it needs a new monitor or maybe one of the rope sensors is bad?. If all else fails, read the instructions

#19602 - 02/17/17 01:01 PM Re: tac 50 04 load weigher [Re: Jcjmowrey]
Joined: Jan 2012 Posts: 885 jkh 4 Ever Learning.
jkh 4 Ever Learning. Joined: Jan 2012 Posts: 885	JC I have a something for you to view, although it's not specific to that model load weigher. Pm your email address to me if you would like it. Make good choices, JKH

#19657 - 02/22/17 12:46 AM Re: tac 50 04 load weigher [Re: jkh]
Joined: Feb 2017 Posts: 3 C not stranger
C not stranger Joined: Feb 2017 Posts: 3	There is two procedures. Calculate the emco unit for empty (peso) then full load (cero). Then calibrate the elevator controller. turn on door disconnect with empty car at top floor type in NLD Go to bottom floor and type NLD put a full load in the car at the bottom floor and type in FLD.

Photo Gallery

Page Time: 0.021s Queries: 16 (0.005s) Memory: 2.6634 MB (Peak: 2.8055 MB) Zlib disabled. Server Time: 2024-05-10 03:49:24 UTC