I'm having a rollback issue on gd1 machine w/ 663 fault and wondering if load weigher is problem . what is command I need to enter in remote fast to view changing load states
Hi there
DLW is the command to look at load data.
In the drive change your EPT to 1
Make sure M98=1 (pre torque enable)
Bump FLD up to .800
Make M39 (Acceleration) lower
If you are still faulting out you can play with the start delay time M43.( Longer is better for roll back issues )
What does the car do when you run with zero speed on inspection.. does it still fault out?
You might have encoder issues.. you are actually getting an excessive torque fault.
Let me know what happens