Hey, can any millar expects chime in. The picture below shows the faults I get when trying to run the car. When a call is placed, the car would move a few feet then stop. It continues this stop and go until it reaches its destination. Is there any manuals or a way to see a detailed explanation of what these faults mean? I couldn't find anything within the diagnostic tool.
The numbers like 5173 ,5145 etc are your tape counts if I remember correct .Will car keep direction runs on inspection up dn if so watch your counts see if jumping around if so ck tape reader connections an guides an clean ck gov tach also your counts in one picture should be going down in count an there all over the place.H on key pad gives more info my book is fron 1992