Book says not getting hall lock, car gate or door close limit, i know i have all 3. Replaced door board, any thoughts? Not very familiar with these units. Thanks
If the computer see's a gate contact, or a door contact, you have to make the close limit inside of 4 seconds. Or if it see's a close limit you have 4 seconds to make up the other two. If not you get a door re-open.
I see them come up in the controller but doors just cycle. I would think i would get a 44 fault more often but i have only seen that once. Doors just keep cycling
Yes close limit is a magnet on clutch. Sensor or bottom of door board mount 46 normally is a door lock when you look at the fault the LEDs will match fault code. You can see if exactly what made and what didn't . Almost it is only as smart as what I/o it sees or where voltage was lost.