Hello I’ve got a fault 0117 on does anybody no the procedure to write parameters back on to drive unit jvop

Thanks

Dear,
Which drive do you have?

0117 is no set up drive fault. You need to do a set up drive.

It’s a yaskawa Drive I’ve been told you it has to see certain mags in the shaft for it to perform a learn run I have tried this when I go into 5-2 it won’t allow me to go to 1 to do a shaft learn any help.....

Need car just below bottom floor with 61u and 30 led,s lit and 61n dark.
Set up should begin when you switch back over to normal