Futura T Loadweigher setup

You are not logged in. [Log In] Home Forums Technical Questions Futura T Loadweigher setup

0 registered members (), 8 guests, and 0 spiders.

Key: Admin, Global Mod, Mod

Newest Members

Forum Statistics

Forums13

Topics6,499

Posts36,809

Members8,395

Most Online117
Jan 16th, 2020

Print Thread

#24871 - 09/28/18 07:34 PM Futura T Loadweigher setup
Joined: Jan 2017 Posts: 35 NONVISIONWINGS newbie
NONVISIONWINGS newbie Joined: Jan 2017 Posts: 35	Anyone know how to setup the loadweighers with the owner service tool? Is there a NLD or FLD command?

#27463 - 07/18/19 04:14 PM Re: Futura T Loadweigher setup [Re: NONVISIONWINGS]
Joined: Dec 2009 Posts: 237 halfpick enthusiast
halfpick enthusiast Joined: Dec 2009 Posts: 237 California	You get any luck on doing that? I'm just trying to figure out how to just bypass the CANRTM

#27464 - 07/18/19 05:53 PM Re: Futura T Loadweigher setup [Re: NONVISIONWINGS]
Joined: Jan 2014 Posts: 736 Rolly old hand
Rolly old hand Joined: Jan 2014 Posts: 736	I believe the Load Weighing is Load cells and they plug into the Car Position Transducer (CPT Board) P17. If your showing an overload condition try unplugging P17.

#27465 - 07/18/19 06:24 PM Re: Futura T Loadweigher setup [Re: NONVISIONWINGS]
Joined: Jan 2014 Posts: 736 Rolly old hand
Rolly old hand Joined: Jan 2014 Posts: 736	Also look at CSW 7 (CS7) Bits 6-7-8-9 control load weighing depending on set or reset. You can change bits with HyperTerminal if you know how to use it. Pretty sure Baud is 19,200 and rest is 8 data N no parity 1 stop bit. You would have to enter password of course.

Photo Gallery