Tac 50-04

You are not logged in. [Log In] Home Forums Technical Questions Tac 50-04

0 registered members (), 22 guests, and 3 spiders.

Key: Admin, Global Mod, Mod

Newest Members

Forum Statistics

Forums13

Topics6,515

Posts36,882

Members8,461

Most Online117
Jan 16th, 2020

Print Thread

#26185 - 03/12/19 08:36 PM Tac 50-04
Joined: Oct 2018 Posts: 10 upndn33 Hackmaster
upndn33 Hackmaster Joined: Oct 2018 Posts: 10	I’m getting an ntsd error as well as a ntsd clamping error.this is a mod which has a tape with the perforated holes any help would be great.i changed the board and it ran for a few hours but crapped out again.i also did a learn run

#26190 - 03/13/19 12:48 AM Re: Tac 50-04 [Re: upndn33]
Joined: Dec 2015 Posts: 1,538 Indirtwetrust ElevatorPractitioner
Indirtwetrust ElevatorPractitioner Joined: Dec 2015 Posts: 1,538 Local 18	Have you checked the magnets on the back of the tape?

#26193 - 03/13/19 08:25 AM Re: Tac 50-04 [Re: upndn33]
Joined: Oct 2018 Posts: 10 upndn33 Hackmaster
upndn33 Hackmaster Joined: Oct 2018 Posts: 10	Yes

#26196 - 03/13/19 04:13 PM Re: Tac 50-04 [Re: upndn33]
Joined: Dec 2010 Posts: 566 elmcannic addict
elmcannic addict Joined: Dec 2010 Posts: 566 S. Central Utah	By “checking the magnets” as IDWT suggested, did you look carefully to be sure there are no gaps at all between magnets, and are they glued in place?

#26546 - 04/13/19 12:16 AM Re: Tac 50-04 [Re: upndn33]
Joined: Mar 2015 Posts: 80 Whadafack journeyman
Whadafack journeyman Joined: Mar 2015 Posts: 80	Do a tbs. adjust your decel before you do it. Bring it up while u do the scan then back down to its original settings

Photo Gallery