Who's Online Now
0 registered members (), 10 guests, and 0 spiders.
Key: Admin, Global Mod, Mod
October
S M T W T F S
1
2 3 4 5 6 7 8
9 10 11 12 13 14 15
16 17 18 19 20 21 22
23 24 25 26 27 28 29
30 31
Newest Members
Rlb3479, Mjak, Pascal, Tamukatech, JasonA
7263 Registered Users
Forum Statistics
Forums13
Topics5,758
Posts33,465
Members7,263
Most Online117
Jan 16th, 2020
Previous Thread
Next Thread
Print Thread
#31937 - 10/13/21 12:13 PM EV10 BLAIN - Jumpy cylinder.  
Joined: Jul 2021
Posts: 11
Sun Offline
stranger
Sun  Offline
stranger

Joined: Jul 2021
Posts: 11
I am having difficulties adjusting a Blain EV10 valve. Here what i have observed while running on construction mode ( High speed valve not enable).

No issue in up direction - at least for now as I am still in construction mode.

In down direction.
The pressure drop from 400psi to around 200 psi and then goes up to 400psi. This causes the piston to jump. By adjusting the control #7 Down Full Speed and # 9 Down Levelling Speed,
the fault cleared. Then, on the next run in the down direction, the fault come back.

I also had an event while adjusting the down controls, 6 Down Acceleration 7 Down Full Speed 8 Down Deceleration 9 Down Levelling Speed. With the stop command enable (no down coil enable), the Cab keeps dropping for 3 feet (400psi) then does the 400psi to 200psi and then stop. I forgot what adjusted to get it stop doing that.

Any idea why this pressure change before stopping?
I did bleed the cylinder 3 times. Run the pump and moved the cylinder upwards. Open bleed valve until oil squeeze out. Could there still be air inside?
I run the pump while opening the emergency valve (I once was told that would clear any dirt)
In this job, we are changing the Pump and Controller. Cylinder and Line rupture valve still the original.

#31950 - 10/14/21 11:51 AM Re: EV10 BLAIN - Jumpy cylinder. [Re: Sun]  
Joined: Jun 2018
Posts: 100
ElevatorGuy128 Offline
member
ElevatorGuy128  Offline
member

Joined: Jun 2018
Posts: 100
Call up Blaine support - 1-720-326-7212 ... always been super helpful in my experience. At the very least with their support you might be able to eliminate the valve as the problem.

#31951 - 10/14/21 12:35 PM Re: EV10 BLAIN - Jumpy cylinder. [Re: ElevatorGuy128]  
Joined: Jul 2021
Posts: 11
Sun Offline
stranger
Sun  Offline
stranger

Joined: Jul 2021
Posts: 11
Thanks. I will try that number.


Photo Gallery
PECCO PH5000 Overspeed Governor
Drive sheave
The best helper.
Rotary Oildraulic
Old Otis badge.
Brakes,Coil,Rotor
KONE MX10 repair tool kit
Powered by UBB.threads™ PHP Forum Software 7.6.0
Page Time: 0.076s Queries: 14 (0.050s) Memory: 2.6631 MB (Peak: 2.8036 MB) Zlib disabled. Server Time: 2022-10-02 06:26:47 UTC