I have an issue with the Doppler lift Asynchronous motor with yaskawa L1000A, I replaced the drive with new one same specs, unfortunately worked only about 1 month, I cloned the whole old parameters to the new one, Now I have OL1 or OL2 error after a months. Any advise regarding this issue please?
thanks in advance

When does the error occur?
Did you check the brakes?
Try to change acceleration and deceleration. Increase the acceleration and deceleration times (C1-01 through C1-08).

Page 269
https://assets.omron.eu/downloads/manual/en/v3/l1000a_users_manual_en.pdf

Dear Jadam,

It happened mostly when Normal mode down direction, INS mode UP and Down was fine.
I have increased C1-01 to C1-08, but no effect (1.5-->3.0), I called the repair team also to check the brake, guide shoes, etc.
When OL1 happened, the monitor showed 59A and the motor rate current was only 21A.