Ladies' and Gentlemen,

I have a OTIS SIGMA with the E124.
I replace the battery for the PDL and set the dip switch to disable.
Everything is dead in the car, no position indicator inside the car or outside the car.
Car is about 6 feet below the top floor.
the controller status ADC = 03
My SW4 Switch is set correctly
My Safety Circuit is good, the R5SX relay is IN but not the R5SC.
I have 48volts going into R5SC but the DOR card is not giving it the ground side
Any help ?

nothing?

I would recommend calling a local elevator company to have them service it.

I AM A LOCAL ELEVATOR MECHANIC,

Check your PM.

PM as in power modular? replaced 1 bad, and 1 good. replaced bad and still same issue. is there a special way to reset these things.
never seen one and all of my Otis connections haven't seen it either. It was bought through Unitec and installed by an independent company and they didn't leave any books behind.

My apologies, the way you'd worded your first post seemed like similar posts by building owners.

Probably means check your private messages (PM) under the my stuff drop down menu on top of the page.

No worries EElevator, Im a partner with a company called Casco Bay Elevator here in Maine. I was told, this sigma is 1 of 2 in the New England area. frustrating trying to get any info on it. The company that installed it was bought out by Kone and the tech that installed it passed in a car wreck.

sorry Montana, ill catch up on to the lingo. I did check PM, nothing yet. thanks every one.

What’s your email address, or private message me.