DMC-I Hall call Problem

You are not logged in. [Log In] Home Forums Technical Questions DMC-I Hall call Problem

0 registered members (), 16 guests, and 2 spiders.

Key: Admin, Global Mod, Mod

Newest Members

Forum Statistics

Forums13

Topics6,532

Posts36,951

Members8,461

Most Online117
Jan 16th, 2020

Print Thread

#32857 - 04/05/22 08:20 PM DMC-I Hall call Problem
Joined: Jan 2019 Posts: 80 M2RE Chilling
M2RE Chilling Joined: Jan 2019 Posts: 80	Hey guys, Recently had the CLC not working, it would turn On then right away off. Changed Power Supply and it started functioning properly, except the hall call circuit, which it would not hold the light. Car arrives but the light will be off the whole time. Happens at all hall stations. Checked fuses, “validate floor” parameter and car is the Master(Single 3stop). I also did 2 Hoistway setup. It does not happens in the car call, only hall up or down dont matter. Any suggestions?

#32858 - 04/05/22 09:50 PM Re: DMC-I Hall call Problem [Re: M2RE]
Joined: Nov 2009 Posts: 413 Johnny Journeyman
Johnny Journeyman Joined: Nov 2009 Posts: 413 Portland. Oregon	Wrong common??? Is this a new job, or an older one?? Is there 24vdc between the commons at the hall stations??

#32860 - 04/05/22 10:18 PM Re: DMC-I Hall call Problem [Re: M2RE]
Joined: Dec 2015 Posts: 1,541 Indirtwetrust ElevatorPractitioner
Indirtwetrust ElevatorPractitioner Joined: Dec 2015 Posts: 1,541 Local 18	The toggle switch in the COP

#32863 - 04/05/22 10:29 PM Re: DMC-I Hall call Problem [Re: M2RE]
Joined: Dec 2015 Posts: 1,541 Indirtwetrust ElevatorPractitioner
Indirtwetrust ElevatorPractitioner Joined: Dec 2015 Posts: 1,541 Local 18	Hall call common is P24G so the buttons light and call the car but the CLC outputs that latch the calls are powered from P24GS. S for Switched, after the 3 pole toggle switch.

Photo Gallery