TAC 32 CPUA replacement?

You are not logged in. [Log In] Home Forums Technical Questions TAC 32 CPUA replacement?

0 registered members (), 29 guests, and 0 spiders.

Key: Admin, Global Mod, Mod

Newest Members

Forum Statistics

Forums13

Topics6,519

Posts36,899

Members8,461

Most Online117
Jan 16th, 2020

Print Thread

#33483 - 07/26/22 09:52 PM TAC 32 CPUA replacement?
Joined: May 2019 Posts: 37 Elevator_Logic Elevator_Logic
Elevator_Logic Elevator_Logic Joined: May 2019 Posts: 37 USA	I have a customer that had a lot of the electrical equipment in the building damaged after a bad storm. It has a duplex setup of Hydraulic Tac 32's. Both controllers had SP/NP bad led on. I have ordered two new 6300XE1 CPUA boards. I am trying to upload the job software to them using the USB thumb drive doing the RST/UDL method but after a few minutes the stat light just blinks red rapidly and the UIT is black block icons. When replacing a CPUA board is there any steps I am missing? Thanks for any help the customer is not being very patient

#33486 - 07/27/22 12:07 AM Re: TAC 32 CPUA replacement? [Re: Elevator_Logic]
Joined: May 2015 Posts: 291 wltr00 enthusiast
wltr00 enthusiast Joined: May 2015 Posts: 291	Did you put the job software in the update folder in the tke folder on the USB stick? Also, are you pressing UDL and then RST and holding down RST until STAT blinks slow, slow, fast, fast?

Photo Gallery