Working on a KONE Resolve 100. Another employee that is out on leave right now pulled the drive and MCU board out to be checked and repaired. Supposedly they have found nothing wrong with the drive or MCU board. I was sent to put it back in. I fire up the car and can’t access any 6 parameters and I comparing parameters on the adjacent car, carB, parameter 1-95 is set to 1. I can’t get 1-95 to save to a 1 on car A. Any thoughts on why I can’t access any 6 parameters or save 1-95 parameters?
Last edited by Twoblocked; 09/29/22 07:40 PM.