Who's Online Now
1 registered members (Indirtwetrust), 10 guests, and 0 spiders.
Key: Admin, Global Mod, Mod
March
S M T W T F S
1 2
3 4 5 6 7 8 9
10 11 12 13 14 15 16
17 18 19 20 21 22 23
24 25 26 27 28 29 30
31
Newest Members
Prairieelevator, Robot Rob, Montkone, Jevans, Clayshooter
8395 Registered Users
Forum Statistics
Forums13
Topics6,468
Posts36,657
Members8,395
Most Online117
Jan 16th, 2020
Previous Thread
Next Thread
Print Thread
#34181 - 11/06/22 03:51 PM Storing Parameters TAC32  
Joined: Feb 2021
Posts: 37
VatorMech93 Offline
newbie
VatorMech93  Offline
newbie

Joined: Feb 2021
Posts: 37
New York, New York
It’s my first time working on a TAC32 and I’ve see the fault log full of 1150 UP RUN STALLED faults. I checked out parameter Z44 which was set to 5 seconds, and changed it to 10. I logged off the IUT, and then reset the mainline to see if my parameter was stored. When I checked, the parameter had returned to 5 seconds. Is there a step I’m missing in storing this parameter?

#34182 - 11/06/22 04:01 PM Re: Storing Parameters TAC32 [Re: VatorMech93]  
Joined: Mar 2016
Posts: 191
lowoil Offline
Elevator guy
lowoil  Offline
Elevator guy

Joined: Mar 2016
Posts: 191
Wisconsin
WRT command

#34183 - 11/06/22 04:04 PM Re: Storing Parameters TAC32 [Re: lowoil]  
Joined: Feb 2021
Posts: 37
VatorMech93 Offline
newbie
VatorMech93  Offline
newbie

Joined: Feb 2021
Posts: 37
New York, New York
I apologize but I’m very new to this controller, can you elaborate?

EDIT: scratch that, I see what you mean now. I’m still trying to get the hang of this UIT.

Last edited by VatorMech93; 11/06/22 04:16 PM.

Photo Gallery
PECCO PH5000 Overspeed Governor
Drive sheave
The best helper.
Rotary Oildraulic
Old Otis badge.
Brakes,Coil,Rotor
KONE MX10 repair tool kit
Powered by UBB.threads™ PHP Forum Software 7.6.0
Page Time: 0.047s Queries: 15 (0.025s) Memory: 2.6605 MB (Peak: 2.8025 MB) Zlib disabled. Server Time: 2024-03-29 14:11:14 UTC