Gentlemen
I have a problem after what I did below.locks This is Only a two stops lift.
1. When I reached, lift was on top floor with cam out of roller. When a call was placed at GF, Top floor door would open and close. Indicator showed 1. Lift could not move because car door was not closing.
2. I switched the lift in inspection, standing on a stool I shorted the car gate switch on car top, closed the landing door and took the lift down in inspection mode.
3. Opened the landing door and removed the shorting.
4. The lift indicator now shows - - when switched to normal.
5. Works in ERO but not taking car and lobby calls when switched to normal.
6. Ran the lift in inspection to GF into DZ to try a system reset. No effect. Lift still displays - - and does not take car calls or hall calls.

Works in inspection but not in normal.

How to make the lift work in normal?